Automatic tape Dispenser |
Automatic tape Dispenser
can be set according tothe length of the cut, and cut off the tape
straight, parallel to paste on theedge,Adhesive tape cutting length,
paste the interval can be adjusted freelyaccording to user needs. |
|
Loading the Tape |
Make sure the SUPPORT
STAND in use.
Make sure the SUPPORT STAND in use.
Turn the POWER SWITCH ON.( A lightly beep sound will come out then the
START BUTTON lights and shows the mode color. )(the default on this tape
dispenser sets number of cut. Red color light on which means 2 pcs. is
set. )
Remove the SAFETY COVER.( The START BUTTON is flashing with Red light. ) |
|
|
Press the START BUTTON and move the CUTTER
BLADE ARM little by little.
( Catch the timing where the cutter blades open most widely.)
Press the START BUTTON continuously, the CUTTER BLADE ARM moves
intermittently. )
Turn the POWER SWITCH OFF.
Plug the cord out.
Pull the TAPE SUPPORT BAR out to the limit. |
Pull the tape under the
BRAKE ROLLER.
Put the tape between the TAPE HOLDER, hooked by TAPE SUPPORT BAR and
through the SLIT (between UPPER and LOWER BLADE) and affix the tape to
the TURN TABLE.
Adjust the TAPE HOLDER to the proper width by sliding the TAPE HOLDER
ADJUSTMENT LEVER.
Instruction
|
|
|
Put the SAFETY
COVER on. Plug in the cord.
Turn the POWER SWITCH ON.
When you use AUTO MODE A (Blue light on) or AUTO
MODE B (Purple light on), stop rotating the TURN TABLE at the SENSOR
which you set. When you use PRESET MODE (Red light on), the TURN TABLE
stop rotating after finishing numbers of cut. )
|
|
Our Recommendation
When you carry ZCUT-870, please hold the bottom of machine. Do not grab
the TURN TABLE.
Make sure the POWER SWITCH is "OFF" when you set the tape
Please follow the instructions when you set the tape. (If you can not
make it,read Instruction Manual carefully and do i t over from the
beginning.)
When ZCUT-870 is not in use,please unplug and switch OFF the POWER
SWITCH.
When you finish using ZCUT-870,remove all the tape from the TURN TABLE
Please do not modify ZCUT-870 by yourself.
ZCUT-870 is designed for tape cutting only. Please do not cut any other
things.
ZCUT-870
cannot be used to cut PVC tape and Fiber tape |
Item Include
1 Set of Automatic Tape
Dispenser Machine ZCUT-870 (151017) |